| "All @ Sea with Lee & Sandy Shore" | ||
|
With just a few manoeuvres and minimum effort the MPS will enable your boat to make headway, above all in the light wind conditions often encountered when cruising. You can forget about the costs and complications associated with using a spinaker pole and any special manoeuvres: the only equipment needed to use an MPS is a halyard, a sheet and an adjustable line for the tack. The MPS is usually designed with an LP of 165% of the J and is somewhat bigger than the largest genoa but smaller than a normal spinnaker.
|
![]() ![]() Click here for 360° View | |
|
To improve handling and reduce the problems of control when compared to a spinnaker, the MPS has a narrower and flatter radial head, which also helps to lower the sails centre of effort. The asymmetrical tri-radial cut makes optimum use of the properties of warp-oriented nylon by reducing stretch and improving control of sail shape. The MPS is very easy to use. Attach it to the adjustable tack line; thread the sheet through the aft block; attach the spinnaker halyard to the head, then bear off, and hoist the MPS covered by the mainsail. When on a very broad reach and running, the adjustable tack line is eased, along with the sheet to set the sail correctly. When on a tight reach the luff is tensioned by tightening the tack line so that the MPS has a shape similar to that of a genoa. This adjustment can be made manually at the bow but it's easier to use a return block and control the tack line from the cockpit. Jibing is easy: ease the sheet, commence to jibe, and when the sail has swung across at the bow, pull the new sheet on. When lowering the MPS, bear off until you're running and let the sail collapse in the lee of the mainsail; then slacken the tack and slowly ease the halyard. You can also choose from the colour range available for nylon sailcloth, provided this is compatible with the panel layout. The Squeezer
| ||
![]() | ||
| Back to Top | ||